Cerca risorse accademiche

Following technical innovations in the field of electrical engineering by Edison, Siemens, and many others, the technology has been introduced into Japan using foreign languages, and then a variety of the technical terms...

Virtual reality (VR) is one of the most common technologies nowadays, which make a virtual environment exactly similar to the real environment. The purpose behind this is to test several issues (designing or manufacturin...

Abstract Current research on the fabrication of rolled composite plates primarily focuses on processing and bonding mechanisms. Compared with hot-rolling technology, the electrically assisted rolling process has demonstr...

Abstract The multicomponent thermal fluid (MTF) process is a pivotal technology for enhancing heavy oil recovery. However, its injection often triggers particle migration and deposition within reservoirs, leading to perm...

Abstract This paper presents a set of design equations for spiral and new scalable cross inductors in CMOS 0.35 μm technology, relating electrical parameters of the inductor's equivalent circuit as functions of its geom...

Arc fault, especially series arc fault, has been the primary cause of electrical fire, which is intermittent, hidden, random and uncertain, difficult to detect, and serious harm. The characteristics of arc fault are firs...

Abstract This paper presents a dual-band resonant cavity in Substrate Integrated Waveguide (SIW) technology to operate in the range from 3.3 GHz to 4.2 GHz, spectrum considered for the Fifth Generation (5G) network. The ...

Abstract This paper describes the design of a compact microstrip microwave diplexer based on bandpass filters and a stepped impedance resonator for 4G applications. The diplexer is composed of two band-pass filters (BPF)...

Abstract This paper presents a design and simulation of a low noise amplifiers (LNA) with all passives elements embedded on low temperature co-fired ceramic (LTCC) substrate. Simulation results in ANSYS Designer and CST ...

Abstract This paper proposes a methodology for developing antipodal Vivaldi antennas using RSIW (Ridge Substrate Integrated Waveguide) technology for a specific cut-off frequency. The technique employs metallic-vias and ...

Abstract This paper presents an effective and novel design procedure employing a novelty named as Perturbation Factor to predict the resonance frequency of resonant cavities in SIW technology perturbed by a shape perturb...

Abstract In this paper, a new microstrip diplexer using modified H-shaped resonators with a compact size and high isolation is presented. This circuit is designed for the ISM band at 2.4 GHz and GPS at 1.575 GHz. The pro...

This paper presents a comprehensive review of Medium Voltage (MV) Wind Energy Conversion Systems (WECS) with the integration of Wide-bandgap (WBG) semiconductor devices. With the growing demand for high-power offshore wi...

AbstractThis paper proposes a new topology of a 2-Stages Active Polyphase Filter (APPF) in MMIC GaAs technology. This new topology, named “radial”, allows a greater balancing of output signals phases and amplitudes, ...

Abstract This paper presents a study about the dielectric constant εr, dielectric loss tangent tan g(δ) and effective electrical conductivity σe of graphene, graphite and graphene-bakelite combination using the resona...

Abstract Photovoltaic (PV) systems have become one of the most important solutions to sustainable energy production due to the growing demand of renewable energy and the necessity to harness energy in the most efficient ...

Electricity consumption measurement system with an embedded system device with Arduino-based technology combined with a current transformer sensor TA12-100 which is connected to the load of electricity consumption. Ardui...

Abstract We propose and experimentally investigate two distinct power-over-Fiber (PoF) approaches, aiming to remotely power Internet-of-Things (IoT) sensing systems for Industry 4.0 environments. The first proof-of-conce...

The concern about the health risks that wireless technology can provide has grown globally thanks to the growing use of the devices by the population, by the finding that the public exposure to EMFs from the devices can ...

Abstract Photonic crystals are periodic structural materials that have an impact on the propagation properties of photons. Due to their excellent optical, electrical and magnetic properties, their advantages and potentia...

Abstract This paper originates from a practical experiment based on Mesh Networks. The promising results obtained from this experiment prompted us to discuss in greater depth whether Wireless Local Area Networks (WLAN) a...

Abstract This paper presents a novel design of an X-band (812 GHz) 4-bit monolithic microwave integrated circuit (MMIC) type true-time-delay (TTD) line for wideband high-resolution imaging radar applications. The designe...

This paper presents a power-efficient RF differential receiver front-end supporting transmitted-reference (TR) communication in a 90 nm CMOS technology. Particularly, it addresses the issues of designing the frontend amp...

Limited telecommunication network services, even for 2G technology, in some regions due to living in small islands, range of hills and blank spot areas are experienced in Indonesian Republic. One of solutions is proposed...