Buscar recursos académicos

Polymeric composites have been widely used in various structural and thermal aerospace applications. Polymeric composites having high strength and high modulus reinforcement are ideally suited for lot of critical aerospa...

This paper describes an easy and time-saving strategy for the fabrication of heterogeneous nanotubular arrays of TiO2-CdS (TCHNTAs) on transparent conductive glass (FTO) and their photoelectrochemical properties. The use...

The illumination of azobenzene molecules with UV/visible light efficiently converts the molecules between trans and cis isomerization states. Isomerization is accompanied by a large photo-induced molecular motion, which ...

Abstract Background Dyspnea is one of the most common symptoms in the post-acute phase of COVID-19 pneumonia. Conventional pulmonary function tests and computed tomography (CT) scores often fail to show correlation with ...

Synthetic dental fiber tape for fiber reinforcement (FRC) restoration is relatively costly and its availability is still limited in Indonesia, so natural dental fibers have been used as an alternative material. The aim o...

This study reports a new optically addressed spatial light modulator (OASLM) structure based on bilateral-sapphire substrates with an air gap that exhibits high-average-power laser resistance. The resistance of tradition...

An all-solid waveguide array fiber (WAF) is one kind of special microstructured optical fiber in which the higher-index rods are periodically distributed in a low-index silica host to form the transverse two-dimensional ...

The efficiency of heterogeneous photocatalysis with TiO2 under UV light (HP) for the removal of uranyl ion from water (0.25mM, pH 3) in the presence of 2-propanol (2-PrOH) was evaluated. The effects of the counterion of ...

Novel binary liquid crystalline systems were obtained by mixing amorphous side-chain polymethacrylate (SCP) and polar compounds. Their thermal and orientational properties were examined by DSC measurement, polarizing mic...

Influence of Immersion Length on Tetracycline Absorption on Gourami (Osphronemus Gouramy) Scales as Adsorbent. Gourami (Osphronemus Gouramy) scales are one of the natural sources of collagen. This fish scale’s collagen...

Influence of weight polymer variation towards sodium fluoride patch physical properties. Fluoride has been proven as a material for strengthen teeth. Many fluoride modalities are available nowadays, and the recent is sod...

Conventional optical fiber has excellent performance in guiding light, which has been widely employed for long-distance optical communication. Although the optical fiber is efficient for transmitting light, its functiona...

This paper sets out the current position with respect to the replacement of dental amalgam as a restorative material. The environmental impact and the question of possible adverse effects of mercury on human health, incl...

Ferroelectric oxide nanocrystals, in combination with the robust coupling of an electric field with crystal structure symmetry, makes such systems agreeable to field-induced crystal structural transformation. The lumines...

Porous ceramics are widely used in fields such as heat insulation, filtration, sound absorption, and catalysis due to their good chemical stability, as well as the high permeability and large specific surface area of por...

In this study, thin nickel oxide nanomembranes were obtained using thermal chemical spraying technology, which involves spraying a green-colored chemical solution at a rate of 30 sprays onto glass substrates with an area...

In the present study, antimony doped tin oxide (SnO2:Sb) thin films are prepared by atmospheric pressure chemical vapor deposition (APCVD) technique by varying the doping concentration in very small range, 1- 1.4 wt.% at...

The temperature coefficient of refractive index dn/dT is determined for glassy allous of the system along the(Ag2S)x(As2S3)100-x, direction (0 < x <20) in the spectral interval of 1–5 μm at temperature of 77– ...

The influence of oxygen pressure in the deposition chamber on the structure, morphology, optical and electrical properties of aluminum doped ZnO films deposited by a layer by layer growth method in magnetron sputtering o...

The latest developments in the field of materials to improve the physical and chemical properties is the use of physical modification of polymeric materials. The specimens of polyepoxy and composites on the base metal ox...

3D solidification of photo-polymerisable mixtures using ultra-short laser pulses can open new directions in formation of glass-ceramics with resolution at tens-of-nanometers.

The increasing global temperatures have escalated the demand for indoor cooling, thus requiring energy-saving solutions. Traditional approaches often integrate metal layers in cooling windows to block near-infrared (NIR)...

El siguiente trabajo intenta evaluar el fenómeno de la discriminación salarial por género en la Argentina. Se utiliza la metodología presentada en Gradín, Del Río y Cantó (2006), que enfatiza la dimensión individ...

O objetivo do trabalho foi a validação de procedimentos de limpeza de vidrarias, utilizando determinação espectrofotométrica de resíduo de vitamina B12, como marcador, para avaliação da eficácia de tal procedi...