Buscar recursos académicos

Abstract The research included the effect of microwaves on Nigella sativa seedling ,which grown on the culture media for germination of seeds and seedling growth. This was done by exposure of seeds to microwaves for diff...

Abstract Callosobruchus maculatus (Fab) is considered one of the important agricultural pests that infests legumes in general and especially cowpea and chickpea resulting devastating damages to these yields. Thus, the a...

In this article, the basic principles and the main applications of Huygens’ metasurfaces (HMSs) are reviewed from microwaves to optics. In general, HMSs comprise a thin layer of orthogonal electric and magnetic dipoles...

In this work, carbon nanotube (CNT) based interconnections and switches will be reviewed, discussing the possibility to use nanotubes as potential building blocks for signal routing in microwave networks. In particular, ...

Chemical modification of asphalt had been used to modify the rheological properties by treatment with sulphur at different experimental conditions. The modification achieved by using application of microwaves (microwave ...

The concern about the health risks that wireless technology can provide has grown globally thanks to the growing use of the devices by the population, by the finding that the public exposure to EMFs from the devices can ...

This work presents a new Ultra Wide Band (UWB) beamforming fifth-order derivative Gaussian pulse transmitter with dual small Vivaldi antennas for remote acquisition of vital signals in impulse radar applications. The sys...

Abstract The paper proposes a high gain, metamaterial based super wideband (SWB) antenna. The SWB antenna has two inverted U slots which are responsible for two notches at 3.5 GHz and 5.5 GHz frequencies. A flower-shaped...

Abstract This article presents the analysis of a hybrid, error correction-based, neural network model to predict the path loss for suburban areas at 800 MHz and 2600 MHz, obtained by combining empirical propagation model...

Abstract A LiDAR architecture for autonomous cars is presented and validated by numerical and experimental results. The proposed scheme is based on indirect time-of-flight principle based on continuous-wave pseudorandom ...

Abstract Radio-Frequency Identification (RFID) is one of the leading enabling technologies of the Internet of Things (IoT) at low cost and high granularity scenarios. The cost of implementing IoT applications concerns th...

Abstract The growing demand for multiparameter sensors includes compact devices accompanied by simple calibration processes to distinguish the outputs from each other. This paper evaluates a scheme to determine multiple ...

Abstract This paper describes an investigation of the possibility of using a new conductive ink, insted of copper clad laminates, in the manufacturing of microstrip patch antennas on glass and fiberglass substrates and o...

Abstract In this article an innovative method of studying and removing the resonances, inherently exhibit by some waveguide to microstrip transitions, is presented. By modeling an equivalent circuit, this new approach al...

Abstract Recently research show that some parameters such as the shapes of antenna patch and the ground plane when geometrically altered produces changes in the current density distribution of the planar structure and co...

Abstract In this paper a 2-4 GHz microstrip IFM (Instantaneous Frequency Measurement) subsystem that uses Wilkinson power dividers, frequency discriminators based on band-stop filters and a DC arduino section is reported...

Abstract In this work a broadband Magnetoelectric (ME) dipole antenna for the Global Navigation Satellite System (GNSS) applied to nanosatellites is proposed. The antenna consists of a reflective cavity with open walls c...

Abstract This paper originates from a practical experiment based on Mesh Networks. The promising results obtained from this experiment prompted us to discuss in greater depth whether Wireless Local Area Networks (WLAN) a...

Abstract This work presents the development of a reconfigurable frequency selective surface (RFSS) for application in the 2400-2483.5 MHz band, standard IEEE 802.11b/g/n (Wi-Fi). The proposed RFSS is based on the four-ar...

Abstract In this article, a small Quad-Band microstrip patch antenna with folded strip lines for WiMAX/WLAN and ITU Applications is presented. This antenna consists eight symmetrical rectangular folded strip lines with 2...

Abstract The presented model for wideband circularly polarized microstrip antenna is an improved version of the previous models which is widely applicable to satellite, microwave relay and radar. The designed circularly ...

In this paper a three layer FSS is described which provides a ultrawide band (UWB) response. The layers use plain rectangular patches, and rectangular patches with one or two notches which provide multi-band responses; b...

This paper shows fundamentals and results that support a promising methodology for evaluation in locus of a LED from its own radiating signal, and that allows monitoring of its aging by remote inference on which degradat...

Abstract This paper presents a reflectarray antenna with an innovative dielectric mirror in the form of a discretized concave reflector. The mirror, manufactured via 3D printing, combines dielectric and air layers, formi...