Cerca risorse accademiche

The main objective of this research work is to develop a new low-cost isolated three-level ac-dc power converter topology with a reduced number of switches. Existing three-level converter topologies change ac power to dc...

Abstract The manufacturing of spiral groove structure of two-dimensional valve (2D valve) feedback mechanism has shortcomings of both high cost and time-consuming. This paper presents a novel configuration of rotary elec...

This article presents the design and experimental validation of a 25-kW bidirectional DC/DC converter employing a dual DAB-CLLC resonant architecture to achieve high efficiency across an ultrawide 200–1000-V opera...

In controlling DC-DC buck converters, the issue of input uncertainties as well as load uncertainties is one of the important challenges in controller design. This paper addresses this issue as well as presents a new robu...

The results of computer simulation of the developed R-2R digital-to-analogue converter design are given. Results with output voltage values for different digital input code are also given. The topology of such device is ...

A five-level cascaded asymmetric multilevel converter is analysed and designed. This topologysynthesises five voltage levels with a reduced number of components when compared to the most common symmetric topologies. It a...

Thin-film lithium niobate (TFLN) has emerged as a promising platform for integrated photonics due to its exceptional material properties. The application of freeform topology optimization to TFLN devices enables the real...

This paper presents an advanced switching sequence based on boundary control for the Dual Active Bridge (DAB) DC-DC converter applied in a Solid-State Transformer (SST). The implementation of the switching sequence follo...

Grid-forming (GFM) converters are increasingly deployed to support power system stability in low-inertia grids. However, the impact of voltage magnitude control strategies on transient stability under fault conditions re...

Abstract Cavitation inside a torque converter induces noise, vibration and even failure, and these effects have been disregarded in previous torque converter design processes. However, modern torque converter application...

The first period-doubling bifurcation of a dc-dc buck converter controlled by a zero-average dynamic strategy is studied in detail. Owing to the saturation of the duty cycle, this bifurcation is followed by a border-coll...

The paper presents the results of computer modeling of the proposed functional-electrical circuit of integrated signal converters (ISC) from photosensitive elements based on CMOS operational amplifiers, which is intended...

Mode division multiplexing (MDM) technology has been well known to researchers for its ability to increase the link capacity of photonic network. While various mode processing devices were demonstrated in recent years, t...

This paper introduces a voltage regulation technique for an isolated power electronic converter that interconnects multiple transformers in series or parallel configurations using switches. This topology, known in the li...

The integration of renewable energy sources (RES), such as wind and solar energy, has become increasingly growth in power generation systems. However, the intermittent and variable nature of these sources poses challenge...

The main objectives of this study are to enhance the power extraction of photovoltaic (PV) systems under rapidly changing ecological circumstances using Maximum Power Point Tracking (MPPT) and to improve the power qualit...

Diamond has attracted great interest as an appealing material for various applications ranging from classical to quantum optics. To date, Raman lasers, single photon sources, quantum sensing and quantum communication hav...

Efficient coupling between optical fibers and on-chip photonic waveguides has long been a crucial issue for photonic chips used in various applications. Edge couplers (ECs) based on an inverse taper have seen widespread ...

Abstract Due to the influence of material characteristics and winding power, single output electromagnet has limited ability to improve the dynamic characteristic of electro-hydraulic valve. Therefore, an electromechanic...

Efficient current control in boost converters is critical for electric vehicle (EV) battery charging applications, where dynamic operating conditions challenge conventional control strategies. This paper presents a novel...

The article analyzes and outlines the modern principles of the theory of the signaling system of automated design with frequency transformations on a non-reciprocal electronic device - the transistor of ultrahigh frequen...

In this work, an all-fiber-based mode converter for generating orbital angular momentum (OAM) beams is proposed and numerically investigated. Its structure is constructed by cascading a mode selective coupler (MSC) and a...