Buscar recursos académicos

Abstract The paper presents a method of calculating the full load engine characteristics based on the Leiderman–Khlystov relation. Because the values of the coefficients of the discussed function available in literatur...

Abstract The conversion of solar radiation into thermal energy has gained increasing attention due to the growing demand for renewable sources of heat and electricity. Nanofluids, owing to their enhanced heat transfer ca...

This paper presents a combined numerical and empirical investigation of how propagation channel conditions shape Modulation Error Ratio (MER) in UHF DVB-T broadcasting. A MATLAB/Simulink DVB-T physical-layer model is ext...

This study analyzes the micropolar nano liquid flow over an obliquely stretched, porous surface with a focus on energy transport. The model incorporates magnetic effects, porosity, and slip conditions in velocity and con...

Power electronic devices are used to integrate clean energy systems (CES) like wind, solar, and other energy sources into the grid to meet the load demand. The parallel operated-inverters (POI) can improve the power capa...

Access to reliable and sustainable power generation in remote areas is a critical challenge faced by many regions worldwide. In such areas, hybrid energy systems integrating solar, wind, and battery components have emerg...

Unbalanced field length exists when ASDA and TODA are not equal. Airport authority may add less expensive substitutes to runway full-strength pavement in the form of stopways and/or clearways to basic TORA to increase op...

The main objectives of this study are to enhance the power extraction of photovoltaic (PV) systems under rapidly changing ecological circumstances using Maximum Power Point Tracking (MPPT) and to improve the power qualit...

Introduction. Scalar control (SC) and field-oriented control (FOC) are widely used in sensorless induction motor (IM) drives for their balance of performance and cost. Among estimation techniques, the voltage-model (VM) ...

The integration of solar energy into modern power grids supports sustainability and energy efficiency but also introduces power quality (PQ) challenges such as harmonic distortion, voltage sag, swell, and fluctuations. I...

Nowadays, ship safety is a significant concern, with over 50% of ship accidents occurring due to collisions. Therefore, accurately predicting the future position of a ship is essential to avoid such incidents. This is pa...

The saturated permeability coefficient of soil is an inherent variable due to its inhomogeneity and the inaccuracy of monitoring. To explore the stability and failure probability of bedrock laminar slope under heavy rain...

Abstract To optimize the magnetic fluid seal design, the single-factor method is usually used to study the effect of the rectangular pole teeth structure parameters on the sealing capacity of the magnetic fluid seal by c...

Robotic technologies are becoming more advanced and are becoming more popular. Requirements are high levels of accuracy and operational speed, such as in surgery and manufacturing. These targets were highly challenging a...

In this study, we developed a single-beam optical trap-based surface-enhanced Raman scattering (SERS) optofluidic molecular fingerprint spectroscopy detection system. This system utilizes a single-beam optical trap to co...

Due to the lack of access to grid electricity, milk preservation is a significant challenge in pastoral and rural areas of most African countries, despite the large volume of milk produced. Integrating milk pasteurizatio...

Abstract With the increasing penetration of power electronic devices in power systems, virtual synchronous generator (VSG) technology has garnered widespread attention for its ability to provide inertia and damping suppo...

Abstract When an output curve force is applied to a horizontal servo cylinder with a heavy load, the piston rod bears a dynamic partial load based on the installation and load characteristics, which significantly affects...

Abstract The friction judder characteristics during clutch engagement have a significant influence on the NVH of a driveline. In this research, the judder characteristics of automobile clutch friction materials and exper...

Abstract This article presents the use of image processing technique to study the effect of injection current on the optical power distribution and laser spot cross-section (profile) of semiconductor laser type (AlGaInP)...

The design of a bistatic inverse synthetic aperture radar (ISAR) images simulator is described, as a response to the need of databases with classification purposes in bistatic radar scenarios characterized by numerous de...

(〖E(8〗_1^+))/(〖E(2〗_1^+)),(〖E(6〗_1^+))/(〖E(2〗_1^+)) , ( 〖E(4〗_1^+))/(〖E(2〗_1^+)) and the ratios of In this study, the energy of the first exited 21+ for 158-170DY even-even isotopes are compared ...

Abstract This study examines the flow and heat transfer behavior of a tri-hybrid nanofluid over an exponentially stretching/shrinking surface, incorporating the influences of thermal radiation, viscous dissipation, inter...

The performance of Photovoltaic (PV) power generation systems, using traditional Vector Current Controllers based on Proportional–Integral Action (CVC-PI), exhibits marked non-linearity and is strongly influenced by me...