Buscar recursos académicos

Raw TiO2 nanoparticles were prepared using the hydroly‐ sis of TiCl4. The nanoparticles were subjected to a surface treatment in diluted sulphuric acid and, subsequently, calcined at different temperatures. Then, a typ...

The race for continuous scaling has been fuelling the electronics industry for the last half a century, allowing unprecedented innovations and achievements. Undoubt‐ edly, silicon and, to some extent, III-V semiconduct...

DCM is classified among the most hazardous atmospheric pollutants and therefore, the development of safe methods for the disposal of residual DCM is of great importance. Activated carbon- supported catalysts containing p...

In this work, we produced nickel oxide nanostructures that show high electrochemical capacitive behaviour, using fungus - one of the most common life forms in nature. Cladosporium cladosporioides fungi are particularly a...

To improve the photocatalytic property of titanium dioxide, titanous sulfate as the titanium source, cobalt nitrate hexahydrate as the cobalt source, undoped and Co 2+ -doped titania nanotubes were prepared via coprecipi...

In this article, a model-based genetic algorithm is used to determine the optical properties of nanostructured zinc oxide single-sided nano thin films that does not depend on the interference fringes of optical transmiss...

A fluorescence resonance energy transfer (FRET)- based aptamer biosensor (aptasensor) for sensitive determination of adenosine triphosphate (ATP) was developed. The energy donor and acceptor were 5′-carboxyfluorescein ...

This Campbell systematic review assesses the effectiveness of school‐based decision‐making. The review summarises findings from 17 impact studies and nine studies of barriers and enablers. School‐based decision‐m...

Carbon nanomaterials are effective adsorbents for water treatment. This study examines natural organic matter (NOM) removal from drinking water with combined coagulation processes using single-walled carbon nanotubes (SW...

Nanopore sensors are expected to be one of the most promising next generation sequencing technologies, with label-free, amplification-free and high-throughput fea‐ tures, as well as rapid detections and low cost. Solid...

In this study, novel titanium dioxide (TiO2) and zinc oxide (ZnO) hybrid photocatalysts in the form of nanofibres were fabricated by a facile method using electrospinning followed by a calcination process. Scanning elect...

This paper reports on miniaturized hydrogen sensing platforms, exploring several means of fabricating nano‐ structured films and evaluating their sensing characteris‐ tics. Palladium-sputtered nanoporous organosilica...

In the present work, the synergistic effect of multiwalled carbon nanotubes and glycidyl polyhedral oligomeric silsesquioxanes on the compression after impact behaviour of multifunctional carbon fibre–reinforced epoxy ...

Heterogeneous photocatalysis using TiO2 is a non-selective technique used for the degradation of organic molecules. Controlling the morphology of TiO2 has recently been considered one of the important approaches for cont...

Ultrafine pure and Mn-doped SnO2 nanoparticles (NPs) were synthesized via the microwave technique. They were produced using tin chloride and hexamethylenetetramine at the molar ratio of 1:20. The concentrations of Mn in ...

In this research, the effects of an Al2O3 nanoparticle additive on the structure and electrical properties of Pb0.88Sr0.12Zr0.54Ti0.44Sb0.02O3 (PSZST) ceramics were investi‐ gated. The PSZST ceramics with the addition ...

The influence of Au nanorods coated with a silica layer on the photoluminescence (PL) of CdTe quantum dots (QDs) was investigated. The Au nanorods were prepared using a seed-mediated method. They were coated with a silic...

This study reported the synthesis of aqueous dispersions of highly stable silver nanoparticles (AgNPs) using gamma radiation with gum acacia (GA) as the stabilizing and protecting agent. The formation of nanosized silver...

Low nano-SiO2 loaded nylon 6 (PA6) nanocomposites were readily produced via in situ polymerization. The effect of surface-modified functional groups of nano-SiO2 on the interfacial structure and properties of nylon 6/SiO...

Upconversion nanoparticles (UCNs) find application in nanomedicine as biolabels to identify cancer cells. In this work, Y2O3: Er3+/ Yb3+ and Gd2O3: Er3+/ Yb3+ systems were fabricated by combustion synthesis (CS) and sol-...

Silver nanowires were synthesized by a polyol method with a detailed control of synthesis conditions such as injection rate, concentration of copper (II) chloride, and silver nitrate to poly(vinylpyrrolidone) ratio. The ...