A Noncontact Voltage Measurement System for Power-Line Voltage Waveforms

This paper presents the design and implementation details of a complete noncontact (NC) voltage acquisition system, which allows the measurement of power-line voltage waveforms without galvanic contact. The system is composed by a novel capacitive probe, an analog front end (AFE), and a microcontroller-based digital signal processing stage. A deep experimental characterization of the noncontact measurement system was performed. The tests reported a high linearity (maximum nonlinearity of ±0.2%), a low input-referred noise (11 mVrms), and a low-frequency response distortion. Measurements of ±330-V triangular waveform signals were performed with maximum instantaneous errors below ±1.5 V. The power-line voltage (220 Vrms at 50 Hz) was acquired without galvanic contact with an instantaneous error lower than ±3 V, whereas the mean error on rms voltage measurements was 0.32% and the maximum 0.7%. A two-day continuous measurement of power-line voltage was accomplished for testing system's stability, resulting in negligible accuracy variations. Fil: Haberman, Marcelo Alejandro. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - La Plata. Instituto de Investigaciones en Electrónica, Control y Procesamiento de Señales. Universidad Nacional de La Plata. Instituto de Investigaciones en Electrónica, Control y Procesamiento de Señales; Argentina Fil: Spinelli, Enrique Mario. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - La Plata. Instituto de Investigaciones en Electrónica, Control y Procesamiento de Señales. Universidad Nacional de La Plata. Instituto de Investigaciones en Electrónica, Control y Procesamiento de Señales; Argentina