Extension of Flow Behaviour and Damage Models for Cast Iron Alloys with Strain Rate Effect

Abstract Cast iron alloys with low production cost and quite good mechanical properties are widely used in the automotive industry. To study the mechanical behavior of a typical ductile cast iron (GJS-450) with nodular graphite, uni-axial quasi-static and dynamic tensile tests at strain rates of 10−4, 1, 10, 100, and 250 s−1 were carried out. In order to investigate the influence of stress state on the deformation and fracture parameters, specimens with various geometries were used in the experiments. Stress strain curves and fracture strains of the GJS-450 alloy in the strain rate range of 10−4 to 250 s−1 were obtained. A strain rate-dependent plastic flow model was proposed to describe the mechanical behavior in the corresponding strain-rate range. The available damage model was extended to take the strain rate into account and calibrated based on the analysis of local fracture strains. Simulations with the proposed plastic flow model and the damage model were conducted to observe the deformation and fracture process. The results show that the strain rate has obviously nonlinear effects on the yield stress and fracture strain of GJS-450 alloys. The predictions with the proposed plastic flow and damage models at various strain rates agree well with the experimental results, which illustrates that the rate-dependent plastic flow and damage models can be used to describe the mechanical behavior of cast iron alloys at elevated strain rates. The proposed plastic flow and damage models can be used to describe the deformation and fracture analysis of materials with similar properties.