Back to results
Bibliographic record · Consultation and access
Artículo

Determination of antimony in airborne particulate matter collected on filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry

Araujo, Rennan G. O. et al · Royal Society of Chemistry · 2010

Supplementary material available
Quick overview. Review the resource’s basic details, then access the content using the main button. This page shows only the information needed to identify, cite, and open the work.

Resource access

Open the content from the main option or choose another available source.

CONICET Digital CONICET Digital OAI-PMH
Entrar por CONICET Digital
Main access

Supplementary material available

El enlace apunta a material asociado, anexos, tablas, datos o página complementaria. No se marca como libro/texto completo.
Open material

Summary

Descripción general del contenido del recurso.

A method has been developed for the determination of antimony in airborne particulate matter collected on glass fiber filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry. The certified reference material, BCR 176 (City Waste Incineration Ash) has been analyzed for validation purposes; no statistically significant difference has been found between the certified and the determined value for antimony based on a Student t-test at a 95% confidence level. The secondary antimony absorption line at 212.739 nm, which is about a factor of 20 less sensitive than the primary resonance line, has been used in order to adapt the sensitivity of the method to the antimony concentration in the samples. 400 μg of ruthenium, thermally deposited on the solid sampling platform has been used as permanent modifier. The characteristic mass at this line was found to be m0 = 0.7 ng Sb. The limit of detection (3σ), based on ten atomizations of an unused filter was found to be 15 μg g-1, corresponding to 40 ng m-3 for a typical air volume of 1440 m 3. The limits of quantification, based on the same measurements were 50 μg g-1 and 128 ng m-3, respectively. The repeatability of the measurements has been between 4% and 9% (n = 5). The antimony concentration found in filter samples varied between <15 μg g-1and 342 ± 16 μg g-1, corresponding to <40 ng m-3 and 1820 ± 90 ng m-3, respectively. Direct solid sample analysis and detection by high-resolution continuum source graphite furnace atomic absorption spectrometry proved to be a simple, fast and reliable alternative for the determination of Sb in airborne particulate matter. An attempt to transfer the method to conventional line source equipment has been without success because of spectral interference and the weak emission of the secondary line from a hollow cathode lamp. Fil: Araujo, Rennan G. O.. Universidade Federal de Santa Catarina; Brasil. Universidade Federal de Sergipe; Brasil Fil: Welz, Bernhard. Universidade Federal de Santa Catarina; Brasil. Universidade Federal da Bahia; Brasil

How to cite

Elegí el formato que necesitás y copiá la referencia al portapapeles.

APA 7

Araujo, R. G. O. E. A. (2010). Determination of antimony in airborne particulate matter collected on filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry. http://hdl.handle.net/11336/54614

MLA

Araujo, Rennan G. O. et al. "Determination of antimony in airborne particulate matter collected on filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry." 2010. http://hdl.handle.net/11336/54614.

Chicago

Araujo, Rennan G. O. et al. 2010. "Determination of antimony in airborne particulate matter collected on filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry.". http://hdl.handle.net/11336/54614.

Harvard

Araujo, R. G. O. E. A. 2010, Determination of antimony in airborne particulate matter collected on filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry, Royal Society of Chemistry, available at: http://hdl.handle.net/11336/54614 [Accessed 10 Aug. 2026].

Share and print

Save the record, copy its permanent link, or print it as a PDF.

Export reference

You can export the record in common formats for use in a reference manager.

Resource details

Bibliographic information to help confirm that this is the correct material.

Title
Determination of antimony in airborne particulate matter collected on filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry
Author / contributors
Araujo, Rennan G. O. et al
Publisher
Royal Society of Chemistry
Publication year
2010
ISSN
0267-9477
ISSN
0267-9477
Language
English

Subjects

Explore related resources through these subjects.

Copied